Sig Marine 200 Manuál s instrukcemi

Direct Draft Propane Heater Operating and Installation Instruction Manual *KEEP THIS MANUAL FOR FUTURE REFERENCE* P9000 & P12000 Model He

10 - After the gas connection is hooked-up, test all gas lines and connections for leaks with a soap solution. Test all

11 5. Lighting Procedure 1) Open heater door 2) Turn GAS knob to LOW only as the high setting will not work when lighting. 3) Press

12 5. Maintenance To keep the heater operating safely and trouble free, it is recommended to periodically perform the following simple inspect

13 fitting from the heater. The orifice is located in the brass fitting. Clean the hole with a wire smaller than a paper clip or try compres

14 Gas odor even when control knob is in OFF position 1. Gas leak. See Warning. Locate and correct all leaks 2. Check and, if required,

15 6. Warranty Policy We at Dickinson & Sig Marine wish to maintain a reasonable and easy system for returns, warranty, returns an

16 ship using the mail service insured and retain a tracking number. Customers are responsible for the shipping costs for all ret

17 maintenance which you are expected to do yourself or have done for you. It is maintenance, which is necessary to keep your p

18 7. Register your Warranty….. Please register your warranty with Sig Marine. Fill out and send back the warranty registration belo

19 Sig Marine Products #101-17728 66 Avenue, Surrey, BC V3S 7X1 Canada Tel: 604-574-8641 Fax: 604-574-8659 E-mail: [email protected] Website: w

2 Table of Contents Table of Contents & Packing List… Pg. 2 Warnings… Pg. 3 1. About a Direct Draft Propane Heater… Pg. 4 2. Important Not

3 WARNINGS - This is a low pressure appliance and MUST have a separate low pressure regulator installed or operation can result in a dang

4 1. About a Direct Draft Propane Heater This direct vent propane heater fireplace is a clean burning low pressure propane appliance

5 3. Installing your Heater Location When installing your new propane heater, keep in mind the location of the heater and where it will maxi

6 Chimney Pipe The stainless double walled flue pipe that is included with the heater is 28” (71cm) long. Four springs are between the inside and ou

7 Deckfitting and Exhaust Cap Step - 1 Measure, cut or drill a 3" hole through the deck, ceiling or wall where the exhaust cap wil

8 4. Connecting the Propane Fuel This is a low pressure propane appliance. Do not use high pressure propane. The heater only operates on low press

9 some of these components vary by manufacturer. Install components as directed by manufacturer’s instructions. Existing System: Part# 1